CEL-MAR ADA-13040MG Manual do Utilizador descarregar pdf (Página 16)

Fig. 17. Example configuration of TCP server

For configuration of TCP Client Settings (Fig 18), select Automatically establish TCP connections, connection between client and

TCP server will be automatically. Then select Always connect and maintain connection option and in section Establish

connection to the following network service enter IP address of device to which TCP client will send data, select service and enter

port. There is also possible to select an option Enable TCP Keep-Alive – connection will be kept, even if the data is not transmitted

over the network.

For saving the configuration press [Apply].

Fig. 18. Example configuration of TCP client

ATTENTION !

Default port of serial port service is 2101.

If on the local network is conflict with other network service using the same port, in the converter's port configuration

change number of port into another for the server and client service .

5.3.2.1.2.2. THE 'ENABLE TCP KEEP-ALIVE' OPTION CONFIGURATION

Option Enable TCP Keep-Alive keeps connection between server and client, even if the data is not transmitted over the network and

reconnection in case of interruption.

Configuration of this option can be made by selection Configuration > Network > Advanced Network Settings > TCP Keep-Alive

Settings. In this section can be configured:

– Idle Time – specifies the period of time (scope 10 sec. - 24 hours) that a TCP connection has to be idle before a keep-alive is

sent.

– Probe Interval – the time in seconds between each keep-alive probe (scope 10 – 75 sec.),

– Probe Count – the number of times TCP probes the connection to determine (scope 5 – 30 trials).

ADA-13040MG

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

CEL-MAR ADA-13040MG Manual do Utilizador Página 16